Sagem WA3050 hard reset

    Before you buy a new cell phone or new tablet, please try the following procedure to repair your device. First charge your battery, backup your important data if possible and in most cases take out SIM and SD card before factory reset. It is impossible to recover your data after doing a hard reset, so online backup is always important. For all of your data, a backup should be done on an external device, hard drive, raid system or media. With or without insurance, if your cell phone lost, damaged or stolen at least your invaluable data is backed up in a safe place. If you are about to sell your phone and you want to wipe your personal data, or if your phone affected with virus you have to do a hard reset. In some cases, you can delete the forgotten password or lock pattern from your device as well.


    Sagem WA3050 soft reset


    Resetting your device and clearing memory

    If your device responds slowly, stops responding as
    expected, or “freezes,” try resetting it. A reset causes the
    WA 3050 to restart and re-adjust memory allocation.
    Unsaved data in open windows may be lost.


    To reset your device


    Use the stylus to press and hold the Reset button for
    about two seconds.

    Sagem WA3050 hard reset
    Note Do not turn off the PDA component when
    resetting your device. Power must remain on in order
    to reset it.

    If you forget your password for accessing PDA features or
    want to clear all data from the WA 3050 and return it to its
    factory settings, you should clear the memory.

     

    Caution Clearing memory deletes all data and restores
    the WA 3050 to its default settings. Any data you have
    created and any programs you have installed are erased.

    To clear memory Sagem WA3050 Hard reset


    1. Disconnect the WA 3050 from external power.
    2. Turn over the device.
    3. Remove first the main battery, then the backup battery.
    4. Wait at least one minute, then replace both batteries.
    5. Turn over your device, then press the PDA power
    ON/OFF button to restart it.
    6. Run through the Welcome Wizard again to reestablish
    your system and calibration settings.
    Note Use ActiveSync to keep a backup copy of your data
    available so that if you need to clear memory, you can
    restore the data.