How to hard reset Motorola A1010

This phone was cancelled but hard reset possible by flashing procedure

1. Charge your battery.
2. Take out SIM and memory card.
3. Turn off your A1010.
4. You have to put your Motorola A1010 into flashing download mode.
5. Press GAME A and GAME B keys together and connect USB cable. Press POWER key to turn on your phone.
6. Release keys.
Start RSD software to upload flash your firmware. Find RSD Lite on XDA dev
Click show device and select firmware. Start flashing procedure. All your content will be lost!
Do not disconnect the device via flashing! After 100% done, your A1010 will restart. Setup your device.

First charge your phone. These pictures are the A1000 which is nearly the same. A1010 was cancelled.
Motorola A1010 flashingMotorola A1000 flashing

General advice: Before you buy a new cell phone or new tablet, please try the following procedure to repair your device in a software way. First charge your battery, backup your important data if possible and in most cases take out SIM and SD card before doing factory reset. It is impossible to recover your data after doing a hard reset, so online backup is always important. For all of your data, a backup should be done on an external device, hard drive, raid system or media. With or without insurance, if your cell phone lost, damaged or stolen at least your invaluable data is backed up in a safe place. If you are about to sell your phone and you want to wipe your personal data, or if your phone affected with virus you have to do a hard reset. In some cases, you can delete the forgotten password or lock pattern from your device as well. All information is for devices with stock based ROMs. If you are using rooted device, always back up your EFS folder first, containing your IMEI info, etc.! Please also note, that a hard reset operation will not unlock your mobile phone's SIM lock or network lock, but it will remove the unlock pattern, remove the user password or PIN password (NOT the SIM card's 4 digit PIN code). Also note that the firmware version will not be affected in any way, it will not be downgraded, it will remain the same you are using and if you have rooted your device, root privileges remain also unaffected.