(Reading time: 1 - 2 minutes)

Resetting is required when an OS or application failure has occurred.
There are two types of resets:
• Normal reset
• Full reset

Pocket Loox 610 BT soft reset

Normal reset is equivalent to restarting a computer, and is required when a trouble has
occurred such as loss of response from the application.
Executing normal reset causes the current data to be discarded.
To execute normal reset, press the reset switch on the left-side of the device body with
the stylus pen, as shown in the figure below.

Fujitsu Siemens Pocket Loox 610 BT hard reset

When pressing the reset switch, be sure to use the accompanying stylus pen.
Using a ball-poin pen or the like may damage the device body.

Pocket Loox 610 BT hard reset full reset

Full reset is equivalent to recovery on a computer, and restores the state of this product
at the time of purchase. This operation is needed when problems such as inability to
start the OS occur.
Executing full reset causes the following data to be discarded:
• Current data
• Data you have created
• Applications you have added
To execute full reset, (1) hold down the power button, and (2) press the reset switch on
the left-side face of the device body with the stylus pen, as shown in the figure below

Fujitsu Siemens  Pocket Loox 610 BT hard reset

General advice: Before you buy a new cell phone or new tablet, please try the following procedure to repair your device in a software way. First charge your battery, backup your important data if possible and in most cases take out SIM and SD card before doing factory reset. It is impossible to recover your data after doing a hard reset, so online backup is always important. For all of your data, a backup should be done on an external device, hard drive, raid system or media. With or without insurance, if your cell phone lost, damaged or stolen at least your invaluable data is backed up in a safe place. If you are about to sell your phone and you want to wipe your personal data, or if your phone affected with virus you have to do a hard reset. In some cases, you can delete the forgotten password or lock pattern from your device as well. All information is for devices with stock based ROMs. If you are using rooted device, always back up your EFS folder first, containing your IMEI info, etc.! Please also note, that a hard reset operation will not unlock your mobile phone's SIM lock or network lock, but it will remove the unlock pattern, remove the user password or PIN password (NOT the SIM card's 4 digit PIN code). Also note that the firmware version will not be affected in any way, it will not be downgraded, it will remain the same you are using and if you have rooted your device, root privileges remain also unaffected.