(Reading time: 1 - 2 minutes)

Master reset Fujitsu-Siemens Pocket LOOX 600

Resetting is an operation that is necessary in such cases as system and
application encounter critical errors and stop respond to input. There are two
types of resets.

• Normal resets
• Full resets

Fujitsu-Siemens Pocket LOOX 600 Soft reset Fujitsu-Siemens Pocket LOOX 600 Normal Resets

A normal reset is equivalent to Restart for a computer. This operation is necessary
when there is trouble such as a program that stops responding.
When you execute a normal reset, the current data will lost.
To execute a normal reset, press the reset button on the rear of the device itself with
the extendable stylus pen as shown in the figure.

Fujitsu Siemens  Pocket Loox 600 hard reset

Always press the reset switch with this device’s extendable stylus pen. Using a ball point pen
or the like can damage this device.

Fujitsu-Siemens Pocket LOOX 600 Full Resets

A full reset is equivalent to recovery for a computer and returns this device to its factory
status. This operation is necessary in such unlikely cases as the system becoming
unable to start.
When you execute a full reset, the following data is lost. Make sure you back up your
data before peforming this step.

• Data being operated on
• Data created by the user
• Added programs

To execute a full reset, operate the battery switch as follows.

1. Open the slide cover.
2. Using the extendable stylus pen, (1) Slide the battery switch to the Off side,
then (2) Slide it back to the On side.

Fujitsu Siemens Pocket Loox 600 hard reset

3. Close the slide cover.
4. Read “Switching on the Power for the First Time

Preparing to Use this Device for the First Time

When using this device for the first time, switch the battery switch On and supply
power to the memory.
1. Use the extendable stylus pen to slide open the battery cover.

Fujitsu Siemens  Pocket Loox 600 hard reset

2. Slide the slide switch to the ON side.

Fujitsu Siemens Pocket Loox 600 hard reset

3. Close the slide cover.

Fujitsu Siemens  Pocket Loox 600 hard reset

Normal Method for Switching on the Power

1. Press the power button.

Fujitsu Siemens Pocket Loox 600 hard reset


General advice: Before you buy a new cell phone or new tablet, please try the following procedure to repair your device in a software way. First charge your battery, backup your important data if possible and in most cases take out SIM and SD card before doing factory reset. It is impossible to recover your data after doing a hard reset, so online backup is always important. For all of your data, a backup should be done on an external device, hard drive, raid system or media. With or without insurance, if your cell phone lost, damaged or stolen at least your invaluable data is backed up in a safe place. If you are about to sell your phone and you want to wipe your personal data, or if your phone affected with virus you have to do a hard reset. In some cases, you can delete the forgotten password or lock pattern from your device as well. All information is for devices with stock based ROMs. If you are using rooted device, always back up your EFS folder first, containing your IMEI info, etc.! Please also note, that a hard reset operation will not unlock your mobile phone's SIM lock or network lock, but it will remove the unlock pattern, remove the user password or PIN password (NOT the SIM card's 4 digit PIN code). Also note that the firmware version will not be affected in any way, it will not be downgraded, it will remain the same you are using and if you have rooted your device, root privileges remain also unaffected.